JDCR-LGDW Series (+20dBm)
JDCR-LGDW Series (+20dBm)
5 Band Consumer Repeater - EU
Product Overview
The JDCR-LGDW Indoor Cellular Repeater is a medium-powered, 5 Band gain adjustable repeater that is perfect for providing wireless coverage to an office building, department store, warehouse, underground parking lot, or multi-story building. Our repeaters help mitigate less than desirable PN scans in RF polluted environments thru the use of high linear amplifiers, properly specified output power limits and a well designed alarm/protection circuitry.
A certified test report is included with each repeater that leaves our factory, so you are assured of strict quality controls.
|
|
SKU:
The JDCR-LGDW 5 Band Cellular Repeater is a medium-powered, gain adjustable, triple band repeater that is perfect for providing wireless coverage inside a large home, office building, restaurant, warehouse, underground parking lot, VIP room, etc. Designed with European networks in mind, this repeater supports 5 frequency bands, making it very convenient. (800 / 900 / 1800 / 2100 / 2600 MHz). The JDCR-LGDW unit is also fully customizable, making design and installation of an indoor system extremely easy. With the use of RF directional couplers and indoor antennas, we can design a solution that fits your specific needs. A typical unit can easily cover up to 55,000 sq ft.
To maintain safe and specific output signal levels, this advanced repeater has built-in AGC and ALC circuits, which can automatically control the gain of the repeater within a 15dB range depending on environmental conditions. In addition, it also has built-in attenuation dip switches that allow you to manually attenuate (fine tune) the repeater's uplink and downlink channels in 1db steps up to 31dB, using color changing LED's as a status indicator. These Alarm LED's are used as a guide to prevent your installation from re-producing errors due to excessive input signal strength if a pre-amp is used, or from signal oscillation due to the indoor antenna and outdoor antenna being too close to each other, which can have adverse effects on a base station.
A Network Safe / MUTE™ feature comes standard with this repeater to protect the cellular network. In short, the repeater will stop transmitting if any errors or signal oscillation is detected within 2-4 sec of detection. It will cycle for 30 sec then attempt to transmit again. If no adjustment in gain has been made to correct the error within the 30 sec MUTE cycle, the system will again shut down after 5 sec. It will run this sequence for a total of 3 times and then shut down completely. Unplugging and powering back up the unit will reset this sequence
The JDCR-LGDW Indoor Repeater is designed to be transparent to the network and will therefore support the same number of calls the BTS in the area can support. It is also compact enough that it can be placed within an electrical closet where space is limited.
Frequency Chart
| Model | Uplink | Downlink | |
|---|---|---|---|
| JDCR-LGDW-20 | LTE800 | 831~861 MHz | 791~821 MHz |
| GSM900 | 890~915 MHz | 935~960 MHz | |
| DCS | 1710~1785 MHz | 1805~1880 MHz | |
| WCDMA | 1920~1980 MHz | 2110~2170 MHz | |
| UMTS | 2500~2570 MHz | 2620~2690 MHz | |
| Filter Bandwidth | Wideband | ||
| Max total output power | ≥15dBm | ≥20dBm | |
| Max. Gain | ≥70dB | ≥70dB | |
| Gain Flatness | LTE & GSM: ≤5dB, DCS & WCDMA: ≤8dB UMTS ≤6dB | ||
| AGC Range | ≧15dB - Auto shut off after 15dB (MUTE) | ||
| Maximum Input Power | 0dBm | ||
| Gain Control Range(MGC) | ≥31dB in step of 1dB by Dip Switch | ||
| V.S.W.R | ≤2 | ||
| Intermodulation | 9KHz~1GHz ≤-36dBm | 9KHz~1GHz ≤-20dBm | |
| 1GHz~12.75GHz ≤-30dBm | 1GHz~12.75GHz ≤-20dBm | ||
| Spurious Emission | 9KHz~1GHz≤-36dBm 1GHz~12.75GHz≤-30dBm |
||
| Spurious Emission Mask | Complies with 3GPP TS 25.106 | ||
| Modulation Accuracy | Complies with 3GPP TS 25.106 | ||
| Peak Code Domain Error | Complies with 3GPP TS 25.106 | ||
| Frequency Stability | ≤0.01ppm | ||
| ACPR | ≥30dB ＠±5MHz＆±10MHz | ||
| Noise Figure (@ max gain) | ≤5dB | ||
| Group Delay | ≤4.5 micro Sec | ||
| Impedance | 50Ω | ||
Mechanical Chart
| Power Supply | Input 90- 264 VAC,50 Hz, transformer: 12V/5A |
| Cooling | Heatsink Convection Cooling |
| Power Consumption | < 35W |
| Operating Temperature | -10°C~+50°C (14F ~ 122F) |
| RF Connector | N Female |
| Weather Proof | IP40 |
| Dimension | 275 x 268 x 300mm (10.83" x 10.55" x 16") |
| Weight | ≤8Kg (17.6Lbs) |
| LED Alarm | Standard |
| Power LED | Power Indicator |
| ALC LED | Amber @ ALC 1~5dB, Red @ ALC 15-20dB |
| LED off after 5 seconds red color |
Drop File