Price: $1,299.00 SKU: JD60-7
The JD60-7 Indoor Cellular Repeater is a high-powered, gain adjustable repeater that is perfect for providing wireless coverage to a large office building, department store, warehouse, underground parking lot, or multi-story building.A certified test report is included with each repeater that leaves our factory, so you are assured of strict quality controls.
Click here to learn the truth about output power ratings.
|
|
The JD60-7 Indoor Cellular Repeater is a high-powered, gain adjustable repeater that is perfect for providing wireless coverage inside a large home, office building, restaurant, warehouse, underground parking lot, VIP room, etc. Several models are available to support any frequency band or technology around the world.
The JD60-7 unit is also fully customizable, making design and installation of an indoor system extremely easy. With the use of RF Signal splitters and indoor antennas, we can design a solution that fits your specific needs. A typical unit can easily cover up to 50,000 sq ft+.
By making use of the latest Gain Adjustable Technology available today, this repeater allows the user to manually increase or decrease the Uplink & Downlink gain levels individually in 1db steps, up to 31dB, by use of dipswitches.
The JD60-7 Indoor Repeater is designed to be transparent to the network and will therefore support the same number of calls the BTS in the area can support. The JD60-7 Repeater is lightweight and compact enough that it can be placed within an electrical closet where space is limited.
To maintain safe and specific output signal levels, this advanced repeater has built-in AGC and ALC circuits, which can automatically control the gain of the repeater within a 15dB range depending on environmental conditions. In addition, it also has built-in color changing LED's as a status indicator. These Alarm LED's are used as a guide to prevent your installation from re-producing errors due to excessive input signal strength if a pre-amp is used, or from signal oscillation due to the indoor antenna and outdoor antenna being too close to each other, which can have adverse effects on a base station.
A Network Safe / MUTE feature comes standard with this repeater to protect the cellular network. In short, the repeater will stop transmitting if any errors or signal oscillation is detected within 2-4 sec of detection. It will cycle for 30 sec then attempt to transmit again. If no adjustment in gain has been made to correct the error within the 30 sec MUTE cycle, the system will again shut down after 5 sec. It will run this sequence for a total of 3 times and then shut down completely. Unplugging and powering back up the unit will reset this sequence
| Model | Uplink | Downlink | |
|---|---|---|---|
| JD60-7-850 | CELL | 824~849 MHz | 869~894 MHz |
| JD60-7-900 | GSM900 | 890~915 MHz | 935~960 MHz |
| JD60-7-18 | DCS | 1710~1785 MHz | 1805~1880 MHz |
| JD60-7-19 | PCS | 1850~1910 MHz | 1930~1990 MHz |
| JD60-7-21 | WCDMA | 1920~1980 MHz | 2110~2170 MHz |
| Filter Bandwidth | GSM & CDMA 25MHz | PCS 60MHz AWS 45MHz | LTE 11Mhz | ||
| Max total output power | ≥15dBm | ≥20dBm | |
| Max. Gain | ≥70dB | ≥70dB | |
| Gain Flatness | CDMA & GSM: ≤8dB, PCS & DCS: ≤10dB | ||
| AGC Range | ≧15dB - Auto shut off after 15dB (MUTE) | ||
| Maximum Input Power | 0dBm | ||
| Gain Control Range(MGC) | ≥31dB in step of 1dB by Dip Switch | ||
| V.S.W.R | ≤2 | ||
| Spurious Emission | 9KHz~1GHz≤-36dBm 1GHz~12.75GHz≤-30dBm |
||
| Spurious Emission Mask | Complies with 3GPP TS 25.106 | ||
| Modulation Accuracy | Complies with 3GPP TS 25.106 | ||
| Peak Code Domain Error | Complies with 3GPP TS 25.106 | ||
| Frequency Stability | ≤0.01ppm | ||
| ACPR | ≥30dB ＠±5MHz＆±10MHz | ||
| Noise Figure (@ max gain) | ≤5dB | ||
| Group Delay | ≤4.5 micro Sec | ||
| Impedance | 50Ω | ||
| Power Supply | Input 90- 264 VAC,50 Hz, transformer: 12V/5A |
| Cooling | Heat Sink Convection cooling |
| Power Consumption | < 35W |
| Operating Temperature | -10°C~+50°C (14F ~ 122F) |
| RF Connector | N Female |
| Weather Proof | IP40 |
| Dimension | 250 x 155 x 53mm |
| Weight | ≤2.5Kg (5.5Lbs) |
| Input Signal Levels | -50dBm or more |
| LED Alarm | Standard |
| Power LED | Power Indicator |
| ALC LED | Amber @ ALC 1~5dB, Red @ ALC 15-20dB |
| LED off after 5 seconds red color |
JD55-PR Series60dB+ Gain Dual or Single Band (2000 - 3000 sq ft) |
JD60-6 Series60dB Gain Single Band (30,000 - 35,000 sq ft) |
JD55-PR Series60dB+ Gain Dual or Single Band (2000-3000sq ft) |
JD60-7-DB70dB Gain Dual Band (35,000 - 50,000 sq ft) |
products approved by:
member of:
We’re open Monday - Friday 9:00am - 5:00pm EST. Call us today! 1-866-4-JDTECK -or- 1-877-4-JDTECK | All Content Copyright © 1999~2012 JDTECK | Orlando Website Design by Designzillas
